Website
40
Elysium
EL18
USB Mode
Set the computer-transmitter recognition mode after the connection via
the USB cable.
--"Ask" After the connection via USB, a pop-up window is displayed,
indicating to select the joystick, U disk or serial mode.
--"Joystick" Connect to the simulator.
--"Storage" Read and modify files in the SD card.
--"Serial" Used to upgrade the firmware.
Default Channel Order
Set the stick mode of each model. If it is selected as AETR, the channel is
CH1-Ail, CH2-Ele, CH3-Thr, or CH4-Rud.
Mode
Set the channel assignment of the left and right sticks.
"1：left=Rud+Ele" It indicates that the left stick corresponds to yaw
and pitch, respectively.
"2：left=Rud+Thr" It indicates that the left stick corresponds to yaw
and throttle, respectively.
"3：left=Ail+Ele" It indicates the left stick corresponds to aileron roll
and pitch, respectively.
"4: left=Ail+Thr" It indicates the left stick corresponds to aileron roll
and throttle, respectively.
7.4.4 Themes
(To be updated...)
7.4.5 Global Functions
Global Functions GF1 to GF64 are allowed to customize functions that
apply to all models, such as specific switches, potentiometers, sliders,
etc. Thus, it is unnecessary to set the same function on "Model Settings"
in the "SPECIAL FUNCTIONS" page. For specific setup, see the "SPECIAL
FUNCTIONS".
7.4.6 Trainer
It is used to select the trainer control or student control for the output
computation mode after the trainer mode is enabled. Assign the trainer
control output channel corresponding to the student control input
channel, to calibrate the stick deviation of both.
There are three options for the output computation mode: "OFF",
"=(Replace)" and "+(Add)".
