Website
15
5.2 Language Selection
5.1 Basic Setting Guidelines
5. Operation Guide
After the preparation is complete, you can follow the instructions in this chapter to get started.
If you use the open-source system for the first time, you can set up the transmitter according to the following basic setting
guidelines:
Language Selection → Mode Selection → Stick Mode → Assign Channel → Stick Calibration → Bind → Protocol Setting →
Failsafe.
• Language Selection
: Refer to "5.2 Language Selection".
• Model Selection
: Refer to "7.1 Select Model".
• Stick Mode
: Select the appropriate stick mode according to your habit. Refer to "7.4.3 Radio Setup → Default Channel
Order and Mode".
• Assign Channel
: Set the channel-related functions. Refer to "7.3.16 Inputs and 7.3.17 Mixes".
• Stick Calibration
: Refer to "7.4.7 Hardware → Inputs → Calibration".
• Bind
: Bind the transmitter with the receiver. Refer to "7.3.5 Internal RF → Bind"
• Protocol Setting
: Set the output signal type of the receiver interface. Refer to "7.3.5 Internal RF → Type → Modules
Option".
• Failsafe
: Set the failsafe. Refer to "7.3.5 Internal RF → Failsafe Mode".
By default, the transmitter is installed with one language. If you need to change the language, you need to update
the firmware. To change Chinese to English, update the Chinese firmware to English firmware. Refer to "5.9 Updating
Transmitter Firmware"
