Website
12
Elysium
EL18
4.1Transmitter Battery Installation
4.2Receiver Installation
4.Before Use
Before operation, please follow the instructions in this chapter to install the battery and connect the device.
Danger • Use only the battery specified by the manufacturer.
Danger • Do not open, disassemble, or repair the battery yourself.
Danger • Do not squeeze, puncture, or touch the metal terminals of the battery.
Danger • Do not expose the battery to high temperatures or liquids.
Danger • Take care to prevent the battery from dropping, bumping or vibrating.
Danger • Store the battery in a dry, cool environment.
Danger • If the battery is damaged, stop using it immediately.
1.
Unscrew both battery compartment covers from the transmitter handles.
2.
Insert 2 18650 batteries into the battery compartments respectively.
•
Please pay attention to the anode and cathode of the battery, refer to
the digram for correct installation.
•
Use two batteries to ensure the power supply capacity of the battery.
3.
Screw the battery compartment covers back into place.
Make sure that the receiver is mounted in an appropriate location within the model, to ensure a stable signal, maximum
range and to mitigate external interference, follow these guidelines:
Pay attention to the following when installing the receiver:
1.
Make sure the receiver is not installed near ESCs or other sources of electrical noise.
2.
Keep the receiver's antennas away from conductive materials such as carbon or metal. To ensure normal function
make sure there is a gap of at least 1cm between the antenna and the conductive material.
3.
Make sure that the two antennas of the receiver are fixed at 90 degrees to each other (as shown below).
Attention
• Do not connect the receiver to the power supply during these steps to avoid damage.
