Fluke Hart Scientific 1523, Technical Manual

Page: 91 / 110

83
Calibration of Your Reference Thermometer Readout
Manual Calibration Process
2. Set the UUT password enable by sending the following commands through the
serial port:
6<673$66&(1;;;;;;;;LVWKHFXUUHQW887SDVVZRUG
4XHU\WKHSDVVZRUGHQDEOHWRHQVXUHFRPPXQLFDWLRQLVZRUNLQJDQGWKDWLWLV
HQDEOHGEHIRUHFRQWLQXLQJ'RWKLVE\VHQGLQJWKHIROORZLQJFRPPDQG
6<673$66&(1"
7KHUHWXUQHGYDOXHVKRXOGEHD,IQRWUHFKHFNWKHVHULDOFDEOHFRQQHFWLRQDQG
WKHWHUPLQDOSURJUDPFRPPXQLFDWLRQVHWWLQJVOLVWHGLQVWHS
3. Set the UUT to the L75_OHMS cal range by sending the following commands
through the serial port:
&$/'(95$1*6(//B2+06
4. Query the Ref points by sending the following Command:
&$/'(95$1*5()"
5. Query the ADJ values for the range by sending the following Command:
&$/'(95$1*$'-"
7KH$'-YDOXHVZLOOEHLQRUGHURIWKHUHISRLQWVTXHULHGLQWKHSUHYLRXVVWHS
6. Set the UUT in the LO_OHMS cal range by sending the following commands
through the serial port:
&$/'(95$1*6(//2B2+06
7. Query the Ref points by sending the following Command:
&$/'(95$1*5()"
8. Query the ADJ values for the range by sending the following Command:
&$/'(95$1*$'-"
7KH$'-YDOXHVZLOOEHLQRUGHURIWKHUHISRLQWVTXHULHGLQWKHSUHYLRXVVWHS
9. Set the UUT in the MED_OHMS cal range by sending the following commands
through the serial port:
&$/'(95$1*6(/0('B2+06
10. Query the Ref points by sending the following Command:
&$/'(95$1*5()"
11. Query the ADJ values for the range by sending the following Command:
&$/'(95$1*$'-"
7KH$'-YDOXHVZLOOEHLQRUGHURIWKHUHISRLQWVTXHULHGLQWKHSUHYLRXVVWHS
12. Set the UUT in the HI_OHMS cal range by sending the following commands
through the serial port:
&$/'(95$1*6(/+,B2+06
13. Query the Ref points by sending the following Command:
&$/'(95$1*5()"
14. Query the ADJ values for the range by sending the following Command:
&$/'(95$1*$'-"