Calibrator
Error Codes
71
Error 7512 result Requested offset exceeds the maximum allowed for this output range and
waveform
Error 7513 result Cannot accept non-coupled command while coupled-commands are queued
Error 7515 result Harmonic must be greater than zero
Error 7516 result Cannot enable 2 wire compensation below [VALUE] in function [FUNCTION]
Error 7517 result Thermocouple reference must be specified as a temperature
Error 7518 result Thermocouple offset must be specified as a temperature
Error 7519 result Cannot have reference below [VALUE] in function [FUNCTION]
Error 7520 result Cannot have reference above [VALUE] in function [FUNCTION]
Error 7521 result Thermocouple offset is limited to +/- [VALUE]
Error 7522 result Cannot use external sense on selected range
Error 7523 result Function not available
Error 7524 result Cannot have line marker above [VALUE] with the selected frame format in
function [FUNCTION]
Error 7525 result Cannot enable external reference in this function
Error 7526 result Trigger Option not available with given primary magnitude
Error 7527 result Cannot change Power Factor for this function
Error 7528 result Cannot change Phase Angle Sign for this function
Error 7530 result The magnitude representation cannot be changed in this function
Error 7531 result Cannot set wave now
Error 7532 result Cannot enable 2 wire compensation above [VALUE] in function [FUNCTION]
Error 7533 result Cannot enter watts with non-sine waveform
Error 7600 result Cannot use boost amplifier now
Error 7601 result Cannot select boost amplifier post now
Error 7602 result Can only output that current on the HIGH post
Error 7603 result Valid Pulse amplitudes are 2.5V, 1V, 250mV, 100mV, 25mV, 10mV
Error 8001 result Power up was less than 30 minutes ago
Error 8002 result Zero adjustment is required every [VALUE] days
Error 8003 result Ohms zero adjustment is required every [VALUE] hours
Error 8012 result Zero adjustment is required every [VALUE] days
Error 8013 result Ohms zero adjustment is required every [VALUE] hours
Error 8101 result Size of X and Y should be the same for Polyfit
Error 8102 result Failed matrix reduction using Gauss-Jordan elimination
Error 8103 result Cannot read coefficients from the matrix
Error 8104 result Missing required input for calculation
Error 8106 result Failed to read matrix coefficients
Error 8107 result TC Measurement is invalid
Error 8108 result Lag bath input needs to be between -10
°
C and 70
°
C
Error 8109 result Entered value out of bounds
Error 8110 result Wrong unit for reference
Error 10001 result Exception happened during json serialization:
Error 10002 result Exception happened during RPC communication
Error 10003 result Unhandled exception:
