Note: Cut off power prior to discharging the water.
Self-cleaning waterway maintenance:
Self-cleaning Waterway Maintenance
When the self-cleaning waterway is blocked,
there is no water coming out during
self-cleaning process.
Current-limiting nut
Current-limiting shaft
Deodorizing Device Maintenance
Unscrew the screws, take out the deodorant box, and replace the none-photocatalyst.
→
It is recommended to replace the none-photocatalyst after 3 years of use (the specific life
span depends on the environment).
→
If you need to replace the none-photocatalyst, please purchase it in the official online store.
1.
Turn off the angle valve.
2.
Unplug the power plug, cut off the power.
3.
Remove the seat, press current-limiting shaft in the middle with a flat-blade screwdriver, then
reinstall the seat, and open the inlet valve.
4.
If there is still no water coming out after pressing current-limiting shaft, use a flat-blade screwdriver
to unscrew current-limiting nut, remove current-limiting shaft, and clean it with a toothbrush or small
brush. After cleaning, replace current -limiting nut and current-limiting shaft to the restrictor In the
device, then reinstall the seat, and open the inlet valve.
Deodorizing
cartridge
None-photocatalyst
Filter cleaning for pressure-maintaining valve
1.
Close angle valve.
2.
Pull out the power plug and cut off the power.
3.
Disassemble the cover and unscrew the filter
connector with a screwdriver.
4.
Take out the filter assembly with nipper pliers.
5.
Brush the filter assembly with a toothbrush and rinse
the filter sediment with clean water.
6.
After cleaning, put the filter assembly and filter connector
back to the original position and tighten it with a screwdriver.
Tips: When cleaning, do not lose or damage the sealing ring on the filter
assembly and the filter connector, otherwise it will cause water leakage.
Filter
Summary of Contents for BID1000W
