Q
Checking the battery charging
level
o
Press the battery charging level button
30
to
check the charging level of the battery
pack
29
. The charging level will be shown on
the battery level indication light
32
.
4 Green LEDs
continuously lit
Battery pack fully charged
3 Green LEDs
continuously lit
Battery pack 75% charged
2 Green LEDs
continuously lit
Battery pack 50% charged
1 Green LED
continuously lit
Battery pack 25% charged
1 Green LED
flashing
Low battery charging level
o
Charge the battery pack
29
before operation
when it is at medium or low battery charging
level.
Q
Assembly
WARNING!
Always switch the product off and
remove the battery pack before
performing inspections, installing
accessories, making adjustments,
refilling fluids or lubricating!
WARNING!
The cutting edges of the saw chain are
sharp! Always wear protective gloves
when handling the saw chain!
Guide bar and saw chain
WARNING!
u
Always use a saw chain designed as “low-
kickback” or a saw chain which meets the
low-kickback requirements! A standard saw
chain (a chain which does not have the
kickback reducing guard links) should only
be used by an experienced professional
operator!
u
Nevertheless, a low-kickback saw chain
does not completely eliminated kickback! A
low-kickback or “safety” chain should never
be regarded as complete protection against
injury! Therefore always use a low-kickback
saw chain in conjunction with other kickback
protection devices!
u
Never attach a new saw chain to a worn
sprocket or place onto a damaged or worn
guide bar. The chain could spring back or
break, potentially leading to serious injury!
Assemble the guide bar
16
and saw chain
17
before operation. Use only a guide bar and
saw chain according to the technical data of the
product (see “Technical data”).
1. Place the product on a suitable flat surface.
2. Loosen the bolts
26
anticlockwise and
remove them together with the cover
25
(see Fig. D).
3. Align the slot with the indexing latches
22
and place the guide bar
16
onto them. Insert
the pin for holding the guide bar
24
into the
lower hole in the guide bar.
4. Place the saw chain
17
around the sprocket
19
and over the guide bar
16
. Make sure
the cutters of the saw chain
17
are facing
away from the product along the top edge of
the guide bar
16
. Fit the chain links into the
groove around the guide bar (see Fig. E).
35
GB / IE