SYS11000OM Rev G
[UF 350-HD, Generic Template]
FLIR Systems Polytech AB
Page
42
of
70
Antennvägen 6
SE-187 66 Täby
Sweden
1.5.3
Symbol area 3
This is used to display the pending Thermal Imager FOV, TV or Spotter Camera FOV
depending on the selected sensor.
XX
: Indicates Thermal Imager Electronic Zoom is not engaged
XXE
: Indicates Thermal Imager Electronic Zoom value of x2 is applied
XX
: Value indicating TV or Spotter camera approximate horizontal FOV in degrees
XXE
: Same as above and x2 electronic Zoom
1.5.4
Symbol area 4
This indicates the status of certain Thermal Imager (TI) and TV features
WHT:
Indicates the Thermal Imager (TI) is displaying White as Hot
BHT:
Indicates the Thermal Imager (TI) is displaying Black as Hot
FLT:
Indicates the TV IR cut off filter is in OUT position
1.5.5
Symbol area 5
AF:
Indicates the selected camera is operating in auto focus mode
MF:
Indicates the selected camera is operating in manual focus mode
1.5.6
Symbol area 6
This is used to indicate the system status and is relevant for both thermal and TV modes
of operation.
FAULT XX:
Indicates that the system self-tests has detected a fault, a two digit code
(XX) reports the nature of the fault. See § 1.7.
FREEZE:
Indicates that the selected camera (TV or TI/IR) is in Freeze mode.
INIT:
Indicates Thermal Imager is cooling down and initializing. The message is removed
when initializing is done. During INIT the camera cannot be controlled from the HCU.
