Flexim FLUXUS WW, User Manual

Page: 12 / 146

FLUXUS WW 2 Safety instructions
12 UMFLUXUS_WWV1-1EN, 2018-02-28
2.7 Safety instructions for transport
• If you detect a transport damage when unpacking the delivery, please contact the supplier or FLEXIM immediately.
• The transmitter is a sensitive electronic measuring instrument. Avoid shocks or impacts.
• Handle the transducer cable with care. Avoid sharp bends or kinks. Observe the ambient conditions.
• Select a solid surface to put the transmitter, transducers and accessories on.
• The transmitter, transducers and accessories have to be properly packed for transport:
– Use, if possible, the original packaging by FLEXIM or an equivalent cardboard box.
– Position the transmitter, transducers and accessories in the middle of the cardboard box.
– Fill any voids with appropriate packaging material (e.g., paper, foam, bubble wrap).
– Protect the cardboard box against humidity.
2.8 Recommended procedure in hazardous situations
Fire fighting measures
• If possible, disconnect the transmitter from the power supply.
• Prior to extinguishing, protect any electrical parts that are not affected by the fire (e.g., using a cover).
• Select a suitable extinguishing agent. Avoid, if possible, conductive extinguishing agents.
• Observe the applicable minimum distances. The minimum distances differ depending on the used extinguishing agent.
2.9 Recommended maintenance intervals
To ensure security, the following maintenance intervals are recommended:
Fig. 2.1: Transmitter FLUXUS FWW
what when
visual inspection for corrosion and damages annually
check of the transducer coupling annually
reading of measured and diagnostic values annually
firmware update check for updates: annually

update as required
replacement of wearing parts backup battery on the main board

replaced by FLEXIM if required
calibration recommendation see chapter 17, section "Calibration"
AVS AV AGN ARS AR BVS BV BGN BRS BR
SA1 SA2 SA3 SA4 SB1 SB2 SB3 SB4 T1a T1b S2 T2a T3a T3b S4 T4a T2b T4b
T1A T1B S1 T2A T3A T3B S3 T4A T2B T4B A+ B- P1+ P2+ P4+ P5a P6a P7a P3+
101 103 P1- P2- P4- P5b P6b P7b P3-
PE N(-) L(+)
front plate