Flavor Burst CTP 80BEV, Equipment, Maintenance And Operations Manual

Page: 60 / 76

59
3. Hang the suspension bracket on the lower
door post and install the Blending Assembly
on the preferred side of the freezer. Install
the Blending Head locking ring fully over the
spout adapter so that the locking collar
covers the tabs on the adapter and rotate
the locking collar to secure.
4. Connect the Drive Motor cable to the Drive
Motor.
5. Use the Gear Box thumb nut to adjust the
suspension bracket horizontally so that it
hangs straight down from the door nut.
6. Use the thumb screw to adjust the bracket
vertically so that it supports the Blending
Assembly in a level position.
7. Tighten the thumb nut and screws to secure
the suspension bracket.
NOTE: THE SUSPENSION BRACKET
SHOULD BE POSITIONED ON THE GEAR
BOX DURING INITIAL SET-UP AND DOES
NOT NEED TO BE REMOVED DURING
OPENING OR CLOSING PROCEDURES
UNLESS IT REQUIRES A MORE THOROUGH
CLEANING.
8. Turn the Blending Head syrup port towards
the 9-Tube Assembly. Insert the manifold
into the Blending Head syrup port and rotate
it until motion stops to secure.
26042
26048
26085
LEVEL
26084
26044