Creator3 User Guide | www.flashforge.com
400-699-1063
20
Level
1. Tap [Level] to start leveling.
2. Wait while the extruder and platform
finish homing movements.
3. Tap to choose extruder adjust level:
Use Left or Right extruder to do the
leveling.
4. Wait while the extruder and platform
finish initial movements. Extruder move
to the first point to do the leveling.
5. Wait for the extruder verifying distance
between nozzle and plate.
6. Operate according to the instruction on
the touch screen, then tap [Verify].
7. Wait for the extruder verifying distance
between nozzle and plate in the first
point.
8. If the distance in the first point is
appropriate, tap [OK] to move to the
next point to do the leveling.
If the distance in the first point is not
appropriate, operate according to the
instruction on the touch screen, then tap
[Verify] again.
Repeat the steps 5 to 8 to do the next two
points leveling
until you see [Finish].
Tap [Finish] to complete leveling.
Note: By tapping [Next Step]
,
you can
skip the point’s leveling, this will
affect leveling result or printing effect.
3
5
1
2
4