Should you encounter any problems, please feel free to email me at: [email protected]
6
Congratulations! You have completed the initial hardware installation! If you're ready to start
printing, proceed to the next step: Software Installation.
Special Notes to Win8 users before Software Installation
Win 8 users please make sure that you have disabled the Driver Signature Enforcement
setting before installing the ReplicatorG software. Below is a video link showing you how
to accomplish this:
http://www.youtube.com/watch?v=NM1MN8QZhnk
Software Installation
ReplicatorG0040 is the best software to use with the dual extruder Creator X. It can be downloaded
from its official website at:
ReplicatorG0040 for Windows users can also be found in the folder of
information of 3D printer
on
the SD card, which shipped together with the Creator X.
Steps for installing your software:
1.
Download the appropriate version of ReplicatorG suitable for your system from
2.
From the SD card shipped with your printer, browse to the “information of 3D printer”
folder and run the Python installation file and the Python acceleration components.
3.
After completing the Python component installation, click Replicator-0040-Installer to
install the Replicator G software.
4.
To run the Replicator G software, double click the shortcut on your desktop or in your
start menu.
The following gives an introduction on how to import files (.STL) into the Replicator G software
and then generate Gcode to print your creation.
Click
File
>
Open
, then browse and select the file (.STL) that you would like to print, import the
file by double-clicking. Then the drawing will appear on the Replicator G interface.