Should you encounter any problems, please feel free to email me at: [email protected]
1
Precautions:
[
★★★
Make sure you read and understand the steps detailed in this guide]
The Creator X is very sensitive to static electricity, so make sure you contact a grounded
object before operating the machine.
Before repairing or making any alterations to the Creator X it is essential that the machine is
turned off and the power cord is unplugged.
The Creator X operates at very high temperatures; allow the nozzle, the extruded plastic and
heating plate to cool before touching.
Some plastic filaments may give off a little odor when heated, because of this the machine
should always be set up in a well-ventilated area.
Do not wear gloves when operating or repairing, as entanglement may occur and cause
injury.
Do not leave the machine unattended when in operation.
Please always check power setting before plug in
FlashForge sets the power supply to default to 230V before leaving the factory. If voltage in your
location is between 90V to 132V, please switch the power setting from 230V to 115V before you
plug in the power. You will find the power source at the bottom of The Creator X.
The red box is where the power setting is located:
What's in the box?
Along with your Creator X 3D printer, this package contains the following:
In two long boxes on the top of the package, you will find:
Power cable,
USB A to B cable,