Should you encounter any problems, please feel free to email me at: [email protected]
16
2.
Using the directional arrows to the right of the screen click the page down key to scroll to
the next page. The display will show:
Preheat
▶
Utilities
Info and Settings
3.
Select
Utilities
; click the
M
key in the middle of the keypad. The display will show:
Monitor Mode
▶
Change filament
Level Build Plate
Home Axes
Feed operation with LCD screen
4.
Select
Change filament
; click the
M
key in the middle of the button board. The display will
show:
▶
Load Right
Unload Right
Load Left
Unload Left
5.
Select
Load right.
Click the
M
key on the button board. The display will indicate: I'm
heating up my extruder! At this time, the temperature of the right nozzle is being heated up.
When the temperature of the nozzle reaches 220 degrees, click the
M
key on the keypad, the
nozzle should start extruding material, if not, keep clicking the
M
key until it does.
Withdrawing using the LCD screen
Notes regarding withdrawing filament!!!
A.
If you just finished your printing or feeding the filament and want to withdraw the filament, at
this moment, the extruder is still over 200 degrees, first push the filament in a little, and then
directly pull it out.
B.
If you want to change another color filament, please firstly do as following shows:
1) Turn on the power switch, you will see the LCD panel shows:
Build from SD
▶
Preheat
Utilities
2)
Using the directional arrows to the right of the screen click the page down key to scroll to the
next page, and
select
Preheat
，
Click
M
key
in the middle
，
then you will see
：
▶
Start Preheat
Right Tool OFF
Left Tool OFF
Platform OFF