65 |
P a g e
TV INSTALLED FLUSH ABOVE FIREPLACE
•
Keep a minimum of 13” inches between the fireplace opening and
the TV.
•
To reduce the amount of heat around and below the TV, increase the
size of the
heat release
above the minimum required for your unit.
•
Hot air flow inside the chase (marked in red arrows) should be
maintained and free from obstruction to allow heat to release freely
at the top of the chase.
•
All measurements shown are minimum requirements.
*Please note that most television manufactures and manuals will instruct the owner not to install television above or near a
fireplace. Mounting a television above the fireplace is based on the owner
’s
decision and responsibility. Flare will not be held
liable for any adverse effects on a TV, artwork or other equipment located near the Flare
appliance. It is the customer’s
or
contractor responsibility to verify that their TV or artwork can withstand the wall temperatures at the installation site.
Summary of Contents for Flare Corner Right & Left 30-100"
