64 |
P a g e
TV INSTALL WITHOUT RECESS
–
MANTEL INSTALLATION
Minimum Requirements for Installing a Television without a
Recess:
•
The TV must be at least 11 Inches total above the glass
of the fireplace
•
A mantel at least 1 inch thick and 6 inches deep should
be installed a minimum of 8 inches above the glass.
•
The TV must be at least 2 inches above the mantel and
1 inch back from the edge of the mantel.
•
To reduce the amount of heat around and below the
TV, increase the size of the
heat release
above the
minimum required for your unit.
•
All measurements shown are minimum requirements.
*Please note that most television manufactures and manuals will instruct the owner not to install television above or near a
fireplace. Mounting a television above the fireplace is based on the owner
’
s decision and responsibility. Flare will not be held
liable for any adverse effects on a TV, artwork or other equipment located near the Flare
appliance. It is the customer’s
or
contractor responsibility to verify that their TV or artwork can withstand the wall temperatures at the installation site.
Summary of Contents for Flare Corner Right & Left 30-100"
