22 |
P a g e
REFLECTIVE BACK INSTALL
The Flare Fireplace may be ordered with a reflective ceramic glass backing. The ceramic glass is tinted black to create
a reflection when the fireplace is running. The ceramic glass will enhance and protect the fireplace look and is very
easy to clean.
The reflective back is shipped outside the unit, inside a sleeve with the other glass panes. It should be mounted at the
back of the fireplace, placed in the gap between the fire bed (shown yellow below) and held by the top mounting
brackets (red circle).
Carefully carry the reflective back using suction cups, and place at a 45-degree angle as shown below.
Screw the mirror clamp as shown below, make sure you do not over-tighten the screw, & leave 1” of the screw
length out.
Summary of Contents for Flare Corner Right & Left 30-100"
