Manual FlexFiller Direct G4
30
70
Supply pressure
sensor no signal
The pressure sensor is not
connected.
Check for loose wiring on the
pressure sensor.
The pressure sensor has failed. Replace pressure sensor
71
Supply pressure
sensor short
circuit
The pressure output range is
out of detectable area. Sensor
needs calibrating
Consult Flamco
The pressure sensor has failed. Replace pressure sensor.
72
Self-learning
correction error
System too small for the unit
Check if the system meets the
size requirements for the unit.
System has no flexibility for
pressure changes
Place an expansion vessel in
the system.
System pipe diameter is too
small
Check the connection
requirements of the unit. Do
not connect the unit to pipes
smaller than the suggested
connection diameter.
73
Manual mode
Manual mode is activated. The
valves can now be manually
activated.
No action needed, the warning
will disappear once manual
mode is exited.
74
Maximum top-up
time exceeded
A large amount of water has
been lost from the system.
Check system for leaks or traces
of water loss.
The unit is undersized for the
system.
Review unit selection
Flood limit time is too short.
Consult Flamco
75
No top-up flow
The mains water supply to the
unit has been isolated.
Turn on the mains water
supply.
The isolation valve at the
bottom of the unit is closed.
Open the isolation valves at the
bottom of the unit.
76
Maintenance 1 is
due
The unit is due an annual
service.
Contact Flamco service
engineer.
77
Maintenance 2 is
due
The unit is due an annual
service.
Contact Flamco service
engineer.
78
Maintenance 3 is
due
The unit is due an annual
service.
Contact Flamco service
engineer.
79
Maintenance 4 is
due
The unit is due an annual
service.
Contact Flamco service
engineer.
80
System fill is
active. Press V to
stop.
System is being topped up from
empty
Press the tick button on the
controller to stop System fill
function
81
System fill is on
hold. Press V to
start.
System has paused top up
because top up time has
exceeded fill time.
If continuing system filling is
required, Press the tick button
on the controller to start
System fill function again.
82
Anti-legionella
flush running
The unit is cleaning the pipes
by flushing water to the drain.
No action needed, this
procedure lasts approximately
2 minutes. Thereafter the unit
will continue normal operation.
Summary of Contents for FlexFiller Direct G4
Page 1: ...www flamcogroup com manuals FlexFiller Direct G4 ENG Installation and operating manual...
Page 33: ...We reserve the right to change designs and technical specifications of our products 33 ENG...
Page 34: ...Manual FlexFiller Direct G4 34...
Page 35: ...We reserve the right to change designs and technical specifications of our products 35 ENG...