517792A
39
2) Check that the clutch teeth are not locked together with dirt, lint,
etc.
3) Make sure the basket is not overloaded with too many clothes.
4) If none of the above appear to be at fault, then check the air bell at
the bottom of the inner basket for leaks.
Secondary Source:
Motor Control Module.
Action:
If the machine is empty of water at fault, it is possible that the pump
circuit is faulty and has caused a pump out during wash. This would
cause the basket to re-engage during agitate and the Motor Control
Module to display this fault. Replace Motor Control Module.
230. (11100110) EEPROM Value out of Range
Wrong version detected
Primary Fault:
Motor Control Module is the wrong version.
Action:
Change Motor Control Module.
232. (11101000) COMMS Timeout 5 Sec
IW only problem, either the Display or Motor Control Module has not responded in time.
Primary Fault:
Display Module fault.
Action:
Replace
Display
Module.
Secondary Fault:
Motor Control Module fault.
Action:
Replace Motor Control Module.
233. (11101001) EEPROM Read Error
Problem reading the EEPROM data coming from the Motor Control Module.
Primary Fault:
Motor Control Module fault.
Action:
Replace Motor Control Module.
234. (11101010) Lid Lock Open Circuit
Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends.
Primary Fault:
Connector to the harness, either end could be at fault.
Action:
Replace Harness.
Secondary Source:
Lid Lock has failed to be activated.
Action:
Replace Lid Lock.
Tertiary Source:
Motor Control Module has not responded to the Lid Lock being
activated.
Action:
Check the lid has a tang and is fitted correctly to activate the Lid
Lock. If this is all in order, the Motor Control Module must be at fault
and needs to be replaced.
235. (11101011) Lid Lock Short Circuit
Lid Lock fault, not activated when instructed to by the Motor Control Module.
Primary Fault:
Lid Lock mechanism has jammed or failed.
Action:
Check resistance across the connections. If out of specification,
replace the Lid Lock, (63
Ω
+/- 10% @ 20
o
C (68
o
F)).
236. (11101100) Incompatible EEPROM Version
Failure to start and fault immediately displayed.
Primary Fault:
Motor Control Module is the wrong version.
Action:
Replace Motor Control Module.
237. (11101111) Temperature Sensor Error
The electronics have picked up a continuity problem, same as fault code 10 or 41.
Primary Fault:
The sensor has failed either in the harness or connection to the
thermistor.
