517792A
31
8
DETAILED FAULT CODES
PHASE 7 EcoSmart
ä
& Intuitive Eco
ä
DETAILED FAULT CODES
INTRODUCTION
The format for fault description in this booklet follows the Primary, Secondary, Tertiary and
Quaternary fault source system. These sources have mostly been arranged in order of most likely
source of fault, but in some cases the sequence has been modified to aid the servicing procedure.
It should be noted that the fault source
Pump System
includes the pump and drain hose
assembly.
These fault codes are specific to the Phase 7 machines.
Fault code shows the last recorded fault. Always confirm fault.
8.1 FAULT
DESCRIPTIONS
1.
(00000001) Motor Control Module Fault
The Motor Control Module has encountered an error when writing to an EEPROM address.
Primary Source:
Motor Control Module.
Action:
Replace Motor Control Module.
3.
(00000011) Motor Control Module Fault
The Motor Control Module has found a memory error.
Primary Source:
Motor Control Module.
Action:
Replace Motor Control Module.
9.
(00001000) Size Switch Error
The Display size switch setting does not match that which is stored in memory.
Action, GW Machines:
Reselect the size of the machine by using the SIZE SETTING
MODE.
To set the size switch, turn the power on at the power point and off at
the console. Press and hold
Wash Temperature Setting Up
then
press
Power
. EcoSmart
â
will give 4 short beeps and the pattern of
LEDs will change.
·
Press
Spin Speed Up
,
the
Spin Hold
LED should be on for the
7.5 / 8.0kg
(650mm wide).
·
Press
Power
to confirm the setting and also exit this mode.
