517792A
24
4.8.3
Hot & Cold Water Temperature LED’s Flashing (No Water)
Possible causes:
1. Check that water is connected and that the taps are turned on.
2. Check that there are no kinks in the inlet hoses.
3. Check that the filters on the inlet hoses at the tap end are not blocked.
4. Check that the filter screens in the inlet valves are not blocked.
5. Check that the flow rate is not too low. The product requires a minimum flow rate of 3 liters per
minute.
6. Check that the drain hose is not too low or the drain hose is not pushed into the standpipe too
far and the water is siphoning out of the machine.
7. Check the size is set correctly.
4.8.4
High Water Level LED Flashing (Overloaded Product)
Possible causes:
1. Check that the product is not overloaded.
2. Check the user has not selected the wrong water level.
3. Check that the rotating basket assembly is not jammed to the agitator with any foreign object
that may be caught under the agitator skirt.
4. Check that the clutch teeth are not locked together with dirt, detergent or lint. Check that the
teeth are not broken.
4.8.5
First Rinse or Final Spin and Current Spin Speed LED Flashing
(Out of Balance)
Possible causes:
1. Check that EcoSmart
â
is correctly installed, is level and does not rock on the floor.
2. Check the bias spring is fitted between the top of the neck ring and the front left hand
suspension rod.
3. Check the suspension is not catching or bouncy. If so, replace all four suspension rods.
4. Check both balance rings on the inner basket contain water. The most accurate way is to
check the weight of the inner basket (Refer to Section 1.12).
5. Check that the holes on the inner basket have been punched through or are not blocked.
4.8.6
Suds (First Rinse LED is flashing or Final Spin LED is flashing)
This warning is generated if the EcoSmart
â
senses too much drag on the inner basket.
1. Too much detergent generally causes this. If so, dissolve the suds by flushing water through
the machine and re-test.
2. Check that the pump is not partially blocked, or that the drain hose is not kinked.
3. Check that a garment or foreign object is not restricting the movement of the inner basket.
4. Check that the main bearings are not tight.
4.8.7
Lid Lock LED Flashing
This warning is generated if the electronics have detected that the lid has not been closed.
1. Check that the tang on the lid is not bent or broken.
2. If the lid is closed and the tang is ok, replace the lid-lock assembly.
4.8.8
Demonstration Mode (All LEDs flashing in patterns)
This feature is designed for in store demonstration purposes. EcoSmart
â
can draw attention to
itself with a selection of flashing LEDs. In this mode EcoSmart
â
cannot be started. To Select
demonstration mode press and hold
Advance
, then press
Power
.
During demonstration mode the LEDs will alternate between all on, LEDs flashing, and all LEDs
off. To return EcoSmart
â
to normal operation, the mains supply must be switched off.
