17
1-13
Pulse Trigger
– This option changes the amount of pulse trigger(s) needed to active the control
module as a slave unit. The default setting requires two ground or 12V+ pulses to activate.
Setting 2 changes the trigger to a triple ground or 12V+ pulse. Setting 3 changes the trigger to a
single ground or 12V+ pulse to activate the remote start sequence.
2-01
Timer Start or Interval Between Cold Start
- This option dictates the time interval when the
control module will remote start.
Default 1:
Will start every 3 hours until the vehicle is remote started or started by key and run for
the set run time in option 1-08.
Option 2:
Will start every 1.5 hours until the vehicle is remote started or started by key and run
time in option 1-08.
2-02
Minimum Crank Time With Tachless Mode
– This option will increase the standard crank time
from 0.8 seconds to 1.4 seconds when remote starting. Please keep in mind that the crank time
will increase with each try.
2-03
Ignition Controlled Locks
– When you turn this option on and have the power door locks
connected, the doors will lock when you remote start or start the vehicle with the key and then
press the foot brake. When you turn the key off the doors will unlock if this feature is turned on.
The feature also requires activation from the remote. Simultaneously tap the Lock + Remote Start
buttons for a half second to activate ignition controlled door locks from the remote. The parking
lights will flash once to indicate this feature is ON.
2-04
Engine Sensing
– This module comes default in Tachless mode where it does not require a tach
connection. Setting 2 changes to the tach sensing where you will need to connect to a wire that
tests as a tach. Setting 3 changes the mode to alternator sensing it does not require a tach
connection. Setting 4 does an assumed start feature where the control module will automatically
crank the yellow starter wire for 1.5 seconds. Please see
the “Common Procedures” section on
page 6-7 of this manual for complete explanations on the four engine sensing modes.
2-05
Minimum Crank Time With Alternator Sensing
– This option will increase the standard crank
time from 0.8 seconds to 1.4 seconds when remote starting. Please keep in mind that the crank
time will increase with each try.
2-06
Diesel Timer
– Use this option when installing on Diesel motors. You can use setting 2 and 3 for
a default wait-to-crank; otherwise, you can adjust the time with your OP-500 Programmer.
2-07
Rearm Output
- This option will change the behavior of the orange wire on CN2. This wire is
used for triggering the factory alarm or shutting the RAP system off.
2-08
Siren Duration
– The default setting for the siren output upon panic or alarm trigger is 30
seconds. You have the ability to extend that with this option. Please see the option tables for
other available settings.
2-09
Siren Output
– The brown wire on CN3 can be changed to output a pulsed (+) 12V output.
2-10
Horn Output
– This option sets the behavior of the horn wire during alarm state, during double
lock from the remote or during lock and unlock from the remote. During one of the options the
event will send a negative pulse on the white wire on CN2.
2-11
Horn Honk
– This option sets the duration of the output on the horn (white) wire. At default it will
pulse depending on option 2-10. At the optional setting it will latch a ground trigger to use for
triggering another siren.
