16
Option Menu Descriptions
1-01
Unlock Before, Lock After Starting
- If enabled, this option will unlock the doors before remote
starting, start the vehicle, then lock the doors after the vehicle starts. It will then lock the doors
again if the remote start run time expires and the vehicle shuts down. The third option locks the
doors upon remote start shut down only. The fourth option turns on lock after remote start
shutdown only. This feature is for vehicles that have factory alarms that need to be disarmed
before remote starting such as Toyota and Lexus.
1-02
Lock / Unlock Pulse Duration
– This option changes the length of the lock and unlock ground
pulses on the blue and blue/black wires on CN4. The default setting is for 0.8 seconds. Optional
setting 2 changes the duration to a 2.5 second pulse. The third setting changes the duration to a
short 0.125 second pulse setting. The fourth setting changes the duration to a 3.5 second pulse.
1-03
Double Pulse Locks
– This option pulses the unlock (blue) wire twice to unlock all doors or
disarm the factory alarm on some vehicles. This feature cannot be used with Option 1-04.
1-04
Driver’s Priority Unlock
– This lets you use the CM-600AS to unlock the driver’s door before the
rest of the doors as in some factory systems. The user has the hit the unlock on the remote a
second time to unlock the rest of the doors.
The driver’s door must be isolated from the other
doors. Use the Orange/Black CN4 as your 2
nd
Unlock output.
1-05
Double Pulse Disarm Wire
– This feature turn the disarm wire into a double pulse output for
shutting down factory alarm outputs.
1-06
IGN + ACC Pulse with Disarm
– This option will pulse the ignition and accessory wires on CN1
at the same time the disarm wire pulses. Most newer Ford/Lincoln/Mercury vehicles need the
ignition and accessory pulsed to disarm the factory alarm.
1-07
Remote Start Runtime
– This option changes the remote start run time from its default 15
minutes to 25, 45, or 3 minutes.
1-08
Auto Rearm
– The system will automatically rearm and relock if there is no activity on the (green)
ignition wire or (red/white) door trigger wires. See the option table for available settings.
1-09
Passive Arming
– This option must be set to 2 before you can turn Passive Arming on with the
remote. Passive Arming will happen only after the door is opened and closed. Simultaneously tap
the Trunk buttons on the remote for a half second to activate passive arming. The
parking lights will flash once to indicate this feature is ON.
1-10
Trunk Output Timing
– This option sets the output duration of the violet/white wire on CN4. The
available options are 1, 0.5, and 2 seconds. You must set the fourth option if you have option 1-
11 on setting 4.
1-11
Unlock/Disarm With Trunk Release
– This option has 4 settings. The settings are self
explanatory but option 4 turns the trunk release wire (violet/white) on CN2 into an Auxiliary 3
which is also programmable via the OP500.
1-12
Dome Light Delay
– This option is used when connecting the door trigger input to the vehicles
dome light circuit. It delays the door trigger input to prevent the
door open notification.
Please
see the option table for available settings.
