5
Remote Code Routine(s)
IMPORTANT:
The included remotes are preprogrammed to the control module. In the event that you
need to program the remotes follow the instructions below.
Programming Remotes to CM600-AS
STEP 1:
Activate Programming mode by turning the ignition key
on
and
off
(between the Acc & On
positions) five times within 7 seconds. The vehicles parking lights will flash once with the successful
completion of this step.
STEP 2:
Within a second after cycling the ignition the 5
th
time, tap the Lock button on the
remote
for a
half second. The parking lights will flash once to confirm the transmitter has been coded.
Programming Multiple Remotes:
After the confirmation flash given
in STEP 2, you can code additional remotes by tapping the Lock
button on the
remote(s)
. The parking lights will flash once confirming
each additional remote. The CM600-AS can store up to three
remotes.
Exiting Programming:
Programming is a timed sequence. If you can
not get the remote(s) to program then the system enters Valet Mode.
The parking lights will flash twice signaling the end of programming
mode.
Placement and Use of Components
IMPORTANT:
The placement and use of components are
critical to the performance of this system.
Antenna and Cable
Firstech antennas are calibrated for horizontal installation
at the top of the windshield. It does not have to be
mounted in the top left corner as shown to the left. The
cable that connects the antenna to the brain must be free
from any pinches or kinks. Installing the antenna in areas
other than the windshield may adversely affect the
effective transmitting distance of the remotes.
Hood Pin
The hood pin is an important safety feature that prevents the remote start from engaging while the hood
is open. This is also to prevent accidental injury in the event that the vehicle is in service.
Antenna
