10
Connector 1 (CN1), 8-Pin Ignition Harness
Pin 1
Red
- Constant 12V positive (+) power input. This wire must be connected. The proper vehicle
wire will test (+) 12V at all times - while the key is in the off position, the on position and during
crank.
Pin 2
Green/White
– This is the positive (+) parking light wire that triggers when you lock and unlock
the doors and remote start the vehicle.
Pin 3
Red/White
- Constant 12V positive (+) power input. This wire must be connected. The proper
vehicle wire will test (+) 12V at all times - while the key is in the off position, the on position and
during crank.
Pin 4
White
- Accessory 12V positive (+) output. This wire must be connected to the vehicle accessory
/ HVAC blower motor wire. The proper wire will test 0V with the key in the off position, (+) 12V
while key is in the on position, 0V while cranking and back to (+) 12V when the key is returned to
the on position.
.
Pin 5
Blue
- Positive 12V (+) output that powers up during remote start. The behavior of this wire is
selectable by a jumper inside the control module. By default this wire powers up as a 2
nd
Ignition
trigger. It is changeable to a 2
nd
Starter or 2
nd
Accessory.
Pin 6
Yellow
- Starter 12V positive (+) output.
This wire must be connected for remote
start. The proper wire will test 0V with
the key in the off position, 0V while the
key is in the on position and (+) 12V
during crank. This wire will be
connected to the starter kill/anti grind
relay at pin 87A.
There are two wires coming off of the
relay; yellow/black and yellow. To utilize
the anti-grind or starter- kill features, the
vehicle's starter wire must be cut in half,
otherwise, cut the relay out of the
harness and connect the yellow (Pin 6)
directly to the vehicle's starter wire. The
starter kill/anti grind relay has a thin 24
gauge blue wire. This must be
connected to pin 2 (24 gauge blue wire)
on Connector 3.
IMPORTANT:
For anti-grind and starter-kill applications, the yellow wire goes to the starter side
of the vehicle's starter wire and the yellow/black goes to the key side.
Pin 7
Green
– Ignition 12V positive (+) output and input. This wire must be connected to the vehicle's
ignition for remote start and valet / remote programming. The proper wire will test 0V with the key
in the off position, 12 V (+) while the key is in the on position and 12V (+) during crank. This pin
will also have an additional wire connected to the starter kill/anti grind relay.
Pin 8
Black
- Ground negative (-) input. This wire mu
st be connected to the vehicle’s ground.
