7
The Vertical Seat Rail Tensioning Bolt is designed to hold the
mid leg 3
-5mm off the floor when the rower is un-weighted
and to allow the
mid leg lightly touch the ground during a weighted rowing stroke.
Tighten the Vertical Seat Rail Tensioning Bolt until the mid leg lifts 3mm
-5mm above of the ground and then
tighten the M10 nut clockwise to
secure the assembly.
Before threading the Vertical Seat Rail Tensioning Bolt into the
Lower Frame Bracket, install the M10 Nut.
Thread the nut upwards as
far as it will go, and then screw the Vertical Seat Rail Tensioning Bolt into
the Lower Frame Bracket.
Important
Installing the Vertical Seat Rail Tensioning Bolt
M10 Nut
Side View
Thread M10 Nut onto bolt here
Step 6:
Install the 150mm Vertical Seat Rail Tensioning Bolt and Plastic Dome Cap
through the Vertical Seat Rail Support Bracket and Seat Rail.
Vertical Seat Rail
Support Bracket
M10x150mm Vertical Seat
Rail Tensioning Bolt and
Plastic Dome Cap
Top View
Fine Tuning the Viking AR Rower
M10 Nut
3-5mm off the ground
Note:
Failure to tighten the M10 Nut could allow the Vertical Seat Rail Tensioning Bolt to move out
of alignment.
If the front of the Viking AR Rower lifts during rowing, this indicates the Vertical Seat Rail Tensioning
Bolt is not correctly adjusted. Loosen the M10 Nut and then adjust height as specified above.
Summary of Contents for Viking AR Rower
Page 1: ...1 Owners Manual ...
