10/01/2021 Rev. 02
10
Power Input
The power port is used to charge the CM
.
(figure 3)
SMPTE Input
The SMPTE port is used to run SMPTE timecode to the CM via an RCA cable. SMPTE is
then automatically distributed to the FMs on the network. (figure 3)
Operator Presence Device (OPD) Input
The Operator Presence Device (OPD) port is used to connect the OPD cable to the CM.
(figure 3)
Antenna Input
The radio antenna is necessary for shows requiring wireless communication; however, the
antenna should always be installed as a backup communications device, even when 2Wire
communications are connected. For greater signal strength and range, raise the height of
the module so that the antenna is at least eight inches (200 millimeters) off the ground. (figure
3)
Graphical User Interface (GUI)
The Graphical User Interface (GUI) is a
128x64- pixel OLED display at the top of
both the CM and FMs (figure 1). Different
pages of the display are used to control
different functions. The HOME, MENU, CT,
WW, MOD, SHOW, and OPN buttons
direct the user to the associated function
page. Other functions and displays may be
reached from each of these function pages.
Figure 3
Figure 4
