Finnlo NRG 3279, Manual

Page: 26 / 48

LEVEL
Shows the resistance in 32 levels in the rpm-dependant exercise. Additional the profi le of the programs, will be shown, too.
5.2.1 Remarks on the individual functions
A) End or break of your exercise
For less than 15rpm/min the computer will recognice an end or break. It will show alternativly the average data for rpm, speed, watt
and the heartrate. The display shows the average sign. After that TRIP will be shown in the display and the values for distance, time and
kcal. The datas can be seen for 4 minutes. After 4 minutes, the computer will go into snooze mode. You can wake him up by pressing
any button.
B) Pulsemeasurement
Pulse measurement with the chest strap: The computer is equipped with a chip, which makes wireless pulse transmission possible using
a chest strap (5.0 – 5.5 kHz).
Handpulse measurement: Plug in the hand pulse cable in the hand pulse plug (Pulse input) at the back of the computer. Please put both
hands on the sensors, which are assembled on the handlebar. If you lift off one hand off the sensor during measuring, it will take some
time to reach the correct watt value.
Both hands have to be kept on the hand pulse sensors.
For a heartrate controlled exercise, please use the chestbelt, which can be bought at the Finnlo Service.
WARNING: Systems with heartrate control can be incorrect. To much exercise could injure your body or can cause
dead. If you feel light theaded or weak, stop your exercise immediately!
C) Fixation of the chestbelt.
Connect the transmitter with
the textile. Adjust the lengh of the textile,
that the chestbelt is fi xed
tighten. The chestbelt has to
be placed under the chest
muscles. The two electrodes should
be wet. Check the correct and most
comfortable position.
25
IMPORTANT: As soon as you use pulse acquisition using the chest strap, this measurement takes priority over any other pulse rate
measurement possibility. In other words, the value is always displayed that results from the measurement by the chest strap.
1 2 3
4