Doc# 71-0170
4215-141
Rev. 02
6
08/23/2022
Knee Wall Installation
13.
After the top plate is installed and side walls are up, install the
knee wall by leaning it in, as shown in (Image 11).
14.
Lean and set the side glass panel into the channel of the knee wall
and connected side wall panel.
(Image 12.A)
NOTE: While the glass should be secure in the channel, it is
recommended a 2nd person hold the glass until the front glass
panel is set and is able to help secure the corner.
15.
With the side glass panel in place, lean and set the front glass
panel into place to butt-up against the glass on the side (Image
M).15Fit the clear rubber gasket of the edges of the glass to seal
and to help hold the glass together
(Image 12.B)
NOTE: When the glass panels are installed, the room should look
like
(Image 12.C)
Glass Transom & Glass Door Installation
16.
After the glass panels and the front wood panel are in place, the
glass transom between the front glass panel and the wood panel
can be installed.
17.
To install, secure the metal connector by clamping the two metal
pieces together to secure the glass and tighten using the Allen
Wrenches (Hex Keys) and secure the transom to the wood panel
using Allen Wrenches (Hex Keys).
DO NOT TIGHTEN UNTIL CEILING PANELS ARE INSTALLED.
18.
With the transom in place, begin installing the hinge to the glass
section to prepare for door installation
19.
Use the Allen Wrenches to secure both sides of the metal hinge to
the glass panel.
20.
The two sides of the metal hinge will sandwich the glass between
two rubber gaskets. Apply to both top and bottom of glass panel.
21.
After the hinges have been installed on the glass section, have
another person hold the glass door in place (Image R), and begin
the installation of the hinges to the door. Follow the same process
as used for the glass panel section (Image S). The Allen Wrenches
will be used again.
Image 11
12.A
12.B
12.C
Image 12
