Doc# 71-0170
4215-141
Rev. 02
4
08/23/2022
INSTALLATION OF SAUNA ROOM
If the sauna is to be placed against existing wall(s), panel installation
should begin away from the wall starting with the right panel. After these
panels are in place, the sauna can be slid back towards the wall(s) keeping
it 1/2” to 1” separation from wall and sauna.
NOTE: Your sauna can be placed on concrete, tile, linoleum, or any
surface that does not absorb water. Do not install the sauna on
carpeting.
All wall panels are numbered at the top and should be readable from the
interior of the room. These numbers will coincide with the numbers on
the base frame.
NOTE: The tongue and groove on the panels will always face the
same direction
Each panel is heavy. Use caution to avoid injury when
installing, especially the roof panels.
Two adults are required for the installation of sauna room.
Base Installation
1.
Position the base frame in the desired location on a level surface.
The largest number on the base frame is the standard door
location. The stamped numbers on the base frame should be
readable from inside of the room.
2.
Fasten the
corners of the base frame using one 3” screw at each
corner in the predrilled holes. Predrilled holes are purposely made
at an angle.
(Image 2)
3.
The base rail is numbered to correspond with the panels.
(Image 3)
NOTE: Using a level and measuring tape, confirm the base
frame is square by measuring corner to corner. The
dimensions should be the same when the base is square.
Shim where needed to level the base.
Wall Panel Installation
Starting with a back wall corner panel. Slide the panel along the base
frame until framework is flush with the outside of the base frame. Hold
the corner so framework is tight up against the framework of the other
panel.
Image 1
Image 2
Image 3
Image 4
