Doc# 71-0170
4215-141
Rev. 02
8
08/23/2022
26.
Place upper bench on upper bench supports. Tilt bench upwards
for easier installation of the lower bench.
27.
Next install the lower bench.
28.
Secure upper bench with two 3” screws through the framework
into the backwall and one 3” screw into right and left
sidewalls.
29.
Two 3/8” holes have been drilled through the frame of the upper
L-
bench. With the top of the benches aligned, use a 3/8” drill bit
and drill through the 2 provided holes and through the face of the
main upper bench. Bolt the two benches together using the 5-
1/2”
carriage bolts provided.
(Image 15)
Backrest Installation
30.
Locate the backrest and remove the backrest mounting hardware
from the backside of the backrest. The longest backrest will be
installed on the back wall, the other will be on the left wall.
31.
Then temporarily invert the backrest with the LED strip on the
bottom and facing outward and connect the low-voltage power
cable from the back wall to the LED lighting strip end. Connect the
12” LED jumper to the other end of
the LED strips. This will be used
to connect the left backrest.
NOTE:
cut 2 pieces of wood to 8 3/8” to use as a gauge block.
Position them on the upper bench to make installation of the
backrest easier.
(Image 17)
32.
Measure 20” from the top of the bench t
o the top of the backrest.
Making sure backrest is level, fasten it to the wall through the
predrilled holes, using 2” screws (provided).
NOTE: If using gauge block carefully remove. Wood plugs are
provided to cover the exposed screw head.
Image 15
Image 16
Image 17
