FINEPLACER
®
lambda
Rev-Nr. 1.1
26
148
Arm fastening screws
2 pcs. of 4 mm hexagon socket screws, M5 thread,
included in the pivot arm assembly, for fixing the pivot
arm (27)
151
Power LED "LINE"
In the front panel of the Placer Control Box (39), ON
means that the mains is connected and live
152
Earth terminal
At the back panel of the Placer Control Box (39)
connected to GND internally, for connecting antistatic
leads from other modules
159
Fine rotation micrometer screw
Optional device, fine rotates the head together with the
component to correct the angle deviation
Θ
(Theta)
160
Height adjustable tracks
To hold the clamped in substrate support or Heating
Plate, which can be height adjusted with the z-
micrometer screw (51a) to find the correct working level
see 2.2
161
Side camera assembly
Observing camera module to watch the process from the
side
162
Bonding Force Module
Boding device to provide a specific force for the bonding
process
163
Balance weight
Counter weight
164
Sliding weight
Allows to choice the appropriate force by sliding the
weight along the scale on the force lever
165
Locking screw
To fix the sliding weight at a definite place.
166
Image fader
For fading the image of either the chip or the substrate
167
Fitting for compressed air
Supplies the cooling (20a) with compressed air via
corresponding Control Box
170
RS 232 connector
Serial connection to a free COM-port of the PC, see 3.3.6
171
Programming switch
Turns the programming mode on/off (only for firmware
updates). If activated, it shines red.
F
OR THE COMMON WORKING PROCESS IT MUST BE
SWITCHED OFF
!
172
Module Interface
Connection for the Module Interface Bus (special cable
supplied), which provides the communication between
all Control Boxes of further modules and the PC within a
Finetech System. The last Control Box at the end of this
bus must be terminated with a terminal resistor plug.
