finetech FINEPLACER lambda, Operator'S Manual

Page: 24 / 45

FINEPLACER ® lambda
Rev-Nr. 1.1
24
18 Zoom Used to view alignment of component and substrate and
to adjust FINEPLACER ® placement accuracy
19 Parallelism fine adjustment screw Rotates the tool around the x-axis to compensate an
angular deviation between tool and working plain
19a Locking screws Locking screws for the parallelism adjust (19)
20 Placement head Fits into head receiver (25) and is locked with screw
(21), holds component to mount
The figure shows a Heated Pick and Place Tool with
cooling option
20a Cooling for the Heated Pick and
Place Tool
Outlet for compressed cooling air
20b Plug for the Heated Pick and Place
Tool
Connector plug to the socket of the corresponding
Control Box
21 Placement head screw of the
Placer Arm
Locks placement head (20) in the head receiver (25)
24 Pipette (with automatic vacuum
switch-over)
Vacuum pickup device for moving component to and
from a tray and vice versa
25 Placement head receiver Holds the placement head (20) at the placer arm.
26 25-pin Sub D electrical connector
(mounted plug)
Provides electrical power to the lighting devices and to
the magnet of the base plate.
27 Pivot arm Holds component in position during alignment and
placement
28 Arm plug Connection between placer arm and Placer Control Box
(39), socket (66)
29 Positioning table Holds a substrate, a substrate support plate or a heating
plate. Floats on air cushion above the base plate (70) for
coarse positioning
30 Beam splitter optics holder
see 4.2.3
Hold the beam splitter
31 Mirror adjustment screws (y)
see 4.2.3
Move the image of the component up & down (y)
relating to the image of the substrate
32 Mirror adjustment screw (x)
see 4.2.3
Moves the image of the component left & right (x)
relating to the image of the substrate
34 Release button for front track Locks or releases front track (23) of positioning table
38 25-pin Sub D Placer Control Box
panel socket
Electrically connects control box (39) to support arm
(71) via connector (26)
39 Placer Control Box Controls all electronic, lighting, vacuum and air
cushion/magnet requirements of the FINEPLACER ® Base
Module's placement and control functions. Features
mains power switching for optional modules
41 Target Lamp intensity knob . I
NACTIVE IF CONNECTED TO THE
FINEPLACER ®
LAMBDA
,
used to control the brightness of the lamps
44 Head vacuum male connector
(Vacuum filter at vacuum hose,
#006)
Connects vacuum hose to head vacuum female
connector (46) at the rear of the Placer Control Box (39)
to provide vacuum to head receiver (25)
46 Head vacuum socket To accept arm vacuum filter (44)
46a Vacuum fine adjusting valve Vacuum fine regulation for the recognition of
components at the used placement head
47 Vacuum mode switch See operating instructions of chapter 3.4.3