fine EP-Q2036HW-IP-AT, User Manual

Page: 18 / 78

-16
-
■POLE MOUNT
Pole mount is applicable to installation on pole with
diameter of 130-150mm (5.12”~6”)
1. Install base.
Put Power/RS485/ Video cables through the
central hole of the bracket base, and then fix it to
the pole
2. Install bracket.
Put cables through the cavity of bracket and fasten
it on base.
3. Release the circuit board.
Unscrew to release the circuit board on connection
board.
4. Install housing.
Cross cables through the hole on top of the housing.
Align the fast connector to bracket and fix with 2
M5 screw
NOTE: Apply water-proof tape to the thread in the
case of outdoor dome
M5 SCREW
TAPE
5. Connect cables.
Plug cables into corresponding sockets on circuit
board. Reinstall the circuit board and turn on the
power. The red LED is on if connections are
correct. Turn off the power after checking.
NOTE: Names of the interfaces are marked on
terminal block or PCB. Connect cables as picture
shows. Make sure power is off before connecting