fine EP-Q2036HW-IP-AT, User Manual

Page: 15 / 78

-13
-
6.Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by configuring
DIP switches (Refer to APPENDIX
Ⅱ
).
SW 1
SW 2
7.Down cover preliminary installation.
Attach the safety chain with a M3 nut as picture shows.
NOTE: Outdoor need plug the heating cable.
8.Install black liner and Pan/Tilt Module.
Push the black liner into the two tabs. Install the pan/tilt
module with two clips, match color of AMP sockets.
Gently push the module upward until hearing the click.
NOTE: Remove the lens cover
AMP SOCKET
Tab
Black Liner
9.Install down cover.
Unscrew the two M4 screw on down cover ring. Push
up the down cover into the housing and then fasten
down cover with two M4 screws.
NOTE: Apply lube to the O-ring in the case of outdoor
dome
lube
M4 slot