fine EP-Q2036HW-IP-AT, User Manual

Page: 13 / 78

- 11
-
■ SURFACE MOUNT
The thickness of the ceiling should be able to hold
the expansion screw and the ceiling is firm enough to
hold 8 times of the weight of the speed dome.
1. Install the mounting base
Take the mount base as patter to mark the mounting
position on the ceiling surface. And then fix the
mounting base on the ceiling. Cross the cables through
the base.
2. Connect cables.
Plug cables into corresponding sockets on circuit
board. When finished, fix the circuit board back
and turn on the power. The red LED will light.
Turn off the power after checking.
NOTE: There are signs for each port. Fix cables as
picture shows. Make sure power is off before
connecting.
3. Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by configuring
DIP switches (refer to APPENDIX
Ⅱ
).
SW 1
SW 2
4. Install black liner and Pan/Tilt Module.
Push the black liner into the two tabs. Install the pan/tilt
module with two clips, match color of AMP sockets.
Gently push the module upward until hearing the click.
NOTE: Remove the lens cover
4. Install down cover
Fasten the safety chain on housing. Align the tabs on
the down cover with the slide holes on the mounting
base. Push the down cover upward and spin it
clockwise to fix the down cover on the mounting
base.