fine EP-Q2036HW-IP-AT, User Manual

Page: 11 / 78

- 9 -
INSTALLATION GUIDE
■IN-CEILING MOUNT
Maximum thickness of the ceiling is 42mm and the
ceiling should be able to hold 8 times of the weight of
the speed dome. More than 20cm of clear space is
needed above the ceiling.
1. Mark the hole on ceiling.
2. Mark a

225 mm circle on the proper position
of the ceiling using the accessory paper sheet
3. Make the hole.
Cut the hole with proper tool. Make sure the
tolerance is less than +2mm.
2 2 5
4.Unfasten the circuit board.
Unscrew the screw to open the circuit board on
connection board.
5.Cross cables.
Prepare wiring and then put Power/RS485/ Video
cables through waterproof connector on the top of
housing. Turn the connector into the top hole of the
housing
Water-proof
Connector
6.Connect cables.
Plug cables into corresponding sockets on circuit
board. When finished, fix the circuit board back
and turn on the power. The red LED will light.
Turn off the power after checking.
NOTE: There are signs for each port. Fix cables as
picture shows. Make sure power is off before
connecting.