fine EP-Q2036HW-IP-AT, User Manual

Page: 12 / 78

- 10
-
7.
Adjust clips.
Adjust the height of the mounting clips. Swing the
mounting clips to adhere to housing.
Ceiling Thickness
Mounting Clip
8.Install housing.
Push housing into ceiling and let the clips stretch
out. Finally, screw the three clips to tighten the
housing
9.Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by configuring
DIP switches (Refer to APPENDIX
Ⅱ
).
NOTE: Remove the packing sponges.
SW 1
SW 2
10.Install Pan/Tilt Module.
Push the black liner into the two tabs. Install the
pan/tilt module with two clips, match color of AMP
sockets. Gently push the module upward until
hearing two clicks.
NOTE: Remove the lens cover
Sam e Color
AM P Socket
Tab
Tab
11.Install down cover.
Fasten the safety chain on housing. Align clasps
and mounting holes then turn clock-wise.
NOTE: Let the safety chain inside the arc groove of
the down cover, otherwise it may scratch the lens.
lube
M4 slot