Fimap MAGNA PLUS, Use And Maintenance Manual

Page: 34 / 48

AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. Select the “transfer” program (see “ DS (DRIVE SELECT) SELECTOR ”).
2. Take the appliance to the dedicated dirty water drainage area.
3. Carry out all the procedures listed in the paragraph “RECOMMENDED PERIODIC MAINTENANCE” (in the column “AT THE END OF THE
WORK”).
4. Once the maintenance work is finished take the appliance to the designated storage place.
5. Secure the machine, see the section titled “ SECURING THE MACHINE ”.
ATTENTION: Park the machine in an enclosed place, on a flat surface, and at a safe distance from any objects that could either damage
it or be damaged due to contact with the machine itself.
ROUTINE MAINTENANCE
Before carrying out any routine maintenance operations, proceed as follows:
1. Take the machine to the maintenance area.
N.B.: the place given over to this operation must comply with current environmental protection regulations.
2. Make sure the machine is in a safe condition (see chapter “ MACHINE SAFETY MEASURES ”).
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
34
INTERVAL MACHINE COMPONENTS PROCEDURE
DAIL
Y; BEFORE
A LONG PERIOD OF INACTIVITY
Squeegee
Clean the vacuum chamber; the squeegee rubber blades; the vacuum nozzle
(see “ CLEANING THE SQUEEGEE BODY ”).
Debris hopper
Empty the debris hopper and clean inside (see “ EMPTYING THE DEBRIS
HOPPER (SWEEPING VERSION) ”).
Brush head brushes
Clean the brushes on the brush head body (see “ CLEANING THE BRUSH HEAD
BODY BRUSHES (SCRUBBING VERSION) ”).
Clean the brushes on the brush head body (see “ CLEANING THE BRUSH HEAD
BODY BRUSHES (SWEEPING VERSION) ”).
Clean the brush on the side brush head body (see “ CLEANING THE SIDE
BRUSH (SCRUBBING VERSION) ”).
Clean the side brushes (see “ CLEANING THE SIDE BRUSH (SWEEPING
VERSION) ”).
Recovery tank
At the end of every working day, empty the recovery tank (see “ EMPTYING THE
RECOVERY TANK ”).
At the end of every working day, after having emptied the recovery tank, clean the
vacuum system filters (see “ CLEANING THE RECOVERY TANK FILTERS ”).
At the end of every working day, after emptying the recovery tank, clean the filter
in the detergent solution recycling system (see “ CLEANING THE RECYCLE
FILTER (FLR VERSION) ”).
At the end of every working day, after having emptied the recovery tank, clean the
vacuum tube (see “ CLEANING THE VACUUM TUBE ”).
Solution tank
At the end of every working day, empty the solution tank (see “ EMPTYING THE
SOLUTION TANK ”).
WEEKL
Y
Machine water system
Clean the filter in the machine's water system (see “ CLEANING THE WATER
SYSTEM FILTER ”).
Squeegee rubber blades
Check that the rubber blades on the squeegee body are intact and inspect for
wear; if necessary, replace these (see “ REPLACING THE SQUEEGEE BODY
RUBBER BLADES ”).
Brush head brushes
Check that the brushes on the brush head body are intact and inspect for wear;
if necessary, replace these (see “ ASSEMBLING THE BRUSH HEAD BRUSHES
(SCRUBBING VERSION)” .
Check that the brushes on the brush head body are intact and inspect for wear;
if necessary, replace these (see “ ASSEMBLING THE BRUSH HEAD BRUSHES
(SWEEPING VERSION)” .
MONTHLY Squeegee rubber blade levelling
Check that the rubber blades on the squeegee body are level and if necessary,
adjust these (see “A DJUSTING THE SQUEEGEE BODY RUBBER BLADES ”).