DRYING
By selecting the "DRYING” program, the command display screen will
appear as in the adjacent figure.
N.B.:
with this working program pressure on the drive pedal only
brings the squeegee to the work position (in contact with the
floor), while the brush head remains in the rest position (raised
from the floor). When the drive pedal is pressed both the suction
motor and the traction motor are powered.
N.B.:
In the DS selector, the drying program symbol (C) is green
(see “
”).
N.B.:
the grey symbols show working programs that are not
active. the green symbols show working programs that are active.
N.B.:
when the drive pedal is released the suction motor will stop with
the respective delay. After the “Reset Delay” time all the squeegee support is taken to the rest position (raised off the floor). by pressing
the forward movement pedal it will start working with the same program and with the same parameters that were set before it stopped.
N.B.:
if you reverse with this program active, the squeegee support is put in the rest position (raised off the floor) and the suction motor is
switched off with the relative delay.
The icons that may be visible on the control panel display are:
1. FFM symbol, if visible it shows that the system is operating.
2. FSS symbol, if visible it shows that the system is operating.
3. Side brush head symbol, if visible it shows that the side brush head is in the working position.
4. Working lights symbol, if visible it shows that the working lights are on.
N.B.:
If you need to activate the dipped headlights when working, see the section “
5. General alarm symbol.
ATTENTION:
if visible, stop the machine. To continue working, see “
6.
If the recovery tank float symbol is visible, this signals that the recovery tank is full and needs to be emptied (see “
7.
8. Eco-Mode button.
N.B.:
if the Eco-Mode button is pressed in transfer mode, the "scrubbing with drying" program is activated in economic mode.
9. Menu button.
10. Rear camera button.
N.B.:
when the rear view camera button is pressed (if present), the camera located at the back of the machine will be activated, see
“
11. Zone button
N.B.:
if you need to change the program in use when working, press the Zone button (read the section “
”).
12. Text indicator.
N.B.:
the text indicator shows which zone program has been selected, or whether the machine is in transport mode if the word “DRIVE” is
visible.
ATTENTION: The drying without scrubbing operation should only be carried out if the device was used
beforehand to carry out a scrubbing without drying operation.
OFFICE
0000.00
100%
9
12
8
10
11
1
5
6
7
2
3
4
ATTENTION: never switch off the machine with the squeegee in contact with the floor
25
