7. Connect the wand kit vacuum tube (3) to the squeegee vacuum tube (5) (
Fig.6
).
8. Activate the vacuum control kit by pressing the button (11); this is located to the rear of the steering column (
Fig.9
).
N.B.:
As soon as the button (11) is pressed, the LED on it will light up (
Fig.9
).
N.B.:
As soon as the button (6) on the control display is pressed, the symbol (7) will appear (
Fig.8
).
WARNING:
never pick up solid matter such as dust, cigarette stubs, paper, etc.
CAUTION:
Never collect gases, explosive/inflammable liquids or powders, nor acids and solvents! These include gasoline, paint thinners
and fuel oil (which, when mixed with the vacuum air, can form explosive vapours or mixtures), and also non-diluted acids and solvents,
acetones, aluminium and magnesium powders. These substances may also corrode the materials used to construct the machine.
CAUTION:
if the machine is used in dangerous areas (e.g. petrol stations), the relative safety standards must be observed. It is forbidden
to use the machine in environments with a potentially explosive atmosphere.
9.
When the work is finished, remove the kit and place it in the storage compartment.
5
5
4
6
3
5
4
3
1
3
2
1
1
2
0000.00
100%
8
7
7
6
SPRAY GUN KIT
On request, the machine can be equipped with the spray gun kit. To use this, proceed as follows:
1. Select the “transfer” program (see “
2. Release the spray gun accessory (at the back of the machine) from the retainers.
3. Activate the vacuum control kit by pressing the button (1); this is located to the rear of the steering column (
Fig.1
).
N.B.:
As soon as the button (1) is pressed, the LED on it will light up (
Fig.1
).
N.B.:
As soon as the button (1) on the control display is pressed, the symbol for the spray gun kit (2) will appear (
Fig.2
).
N.B.:
With the spray gun kit active, the traction and work functions are deactivated.
CAUTION:
When using the optional tank cleaning kit, you are advised to always wear goggles to avoid any risk of serious injury to your
eyes.
N.B.:
Before using the optional tank cleaning kit, check the level indicator positioned on the left-hand side of the machine to see how
much solution there is in the solution tank.
4. Activate the solution jet by pressing the lever in the tank cleaning accessory. Make sure the jet is pointing into the tank before pressing the
lever.
N.B.:
To adjust the solution jet from the tank cleaning accessory, turn the knob (3) on the accessory itself (
Fig.3
).
N.B.:
To adjust the intensity of the solution jet from the tank cleaning accessory, turn the knob (4) on the accessory itself (
Fig.4
).
N.B.:
To stop the solution jet, use the lever (5) on the tank cleaning accessory (
Fig.5
).
3
3
4
5
4
5
DRIVE
0000.00
100%
2
2
1
1
33
