HOW TO MOVE THE MACHINE
To transport the machine safely, proceed as follows:
DANGER:
before starting any task, make sure the current regulations concerning the safe transport of dangerous substances are
scrupulously observed.
1. Check to make sure that the solution tank and the recovery tank are empty. If this is not the case, empty them (see the sections titled
“
”).
2. Sit on the driver’s seat.
3. Insert the key (2) into the main switch on the control panel. Move the main switch to the "I" position by turning the key (2) a quarter turn
clockwise (
Fig.6
).
4. Using the DS selector on the command display (
Fig.7
), activate the “transfer” program (6) (see “
”).
N.B.:
the grey symbols show working programs that are not active. the green symbols show working programs that are active.
5. Press the drive pedal (8) (
Fig.9
) to begin moving the machine.
6. Use a ramp to move the machine up onto the transport vehicle.
CAUTION:
During this operation, check there are no people or objects near the machine.
N.B.:
the ramp gradient must not be such as to cause damage to the machine as it goes up.
7. Position the machine on the means of transport, and set the main switch to “0” by turning the key (2) a quarter turn anti-clockwise (
Fig.2
).
Remove the key from the main switch.
8.
Get off the machine.
CAUTION:
when getting down from the machine, do not place your foot on the scrubbing brush head or side brush head brush.
9. Grip the back of the seat (3) and turn the seat support plate to its maintenance position (
Fig.3
).
ATTENTION:
to prevent the seat from rotating, insert the retainer (4) into the slot (5) (
Fig.4
).
10. Disconnect the battery connector from the machine's main system connector (
Fig.5
).
11. Grip the back of the seat (5) and turn the seat support plate to the working position.
N.B.:
before rotating the seat support plate, remove the retainer (4).
WARNING:
secure the device according to the directives in force in the country of use, so that it cannot slide or tip over.
21. Grip the handle (4) and lower the recovery tank to its working position.
22. Grip the back of the seat (3) and turn the seat support plate to the working position.
13
