DRAINING THE RECOVERY TANK
Proceed as follows to empty the recovery tank:
1. Remove the drainage hose of the recovery tank from the clamps; it is located at the rear of the machine (
Fig.1
).
2. Bend the end of the drainage tube in order to create a choke and prevent the content from coming out (
Fig.2
), then position the tube on the
discharge surface, unscrew the cap, and gradually release the tube.
3. Repeat the operations in reverse order to reassemble all the parts.
EMPTYING THE DEBRIS HOPPER (SWEEPING VERSION)
The thorough cleaning of the debris hopper ensures better floor cleaning performance. To empty the debris hopper, proceed as follows:
1. Open the machine's left lateral carter (1) (
Fig.3
).
2. Release the debris hopper locking pin (2) (
Fig.4
).
3. Use the handle (3) to extract the debris hopper (
Fig.5
) and empty it.
4. Clean the inside with a jet of water, and use a brush to remove any residual impurities if necessary.
5. Proceed in the opposite order to reassemble all the parts.
CLEANING THE SQUEEGEE BODY
The careful cleaning of the whole vacuum unit ensures better drying and cleaning of the floor as well as a longer vacuum motor life. To carry out
the cleaning of the squeegee body, proceed as follows:
1. Extract the vacuum hose (4) from the vacuum nozzle on the squeegee body (
Fig.6
).
2. Completely unscrew the knobs (5) on the squeegee body pre-assembly (
Fig.7
).
3. Remove the squeegee body from the slits in the squeegee connector (
Fig.8
).
35
34
4
33
32
27
28
31
26
30
29
27
25
22
23
28
24
26
21
25
24
22
23
17
20
18
19
16
21
15
19
20
18
13
14
17
15
16
11
12
12
14
13
12
8
9
10
7
8
6
4
5
11
9
10
6
7
4
5
3
2
1
3
2
1
