SCRUBBING WITH DRYING
By selecting the "SCRUBBING WITH DRYING” program, the command
display screen will appear as in the adjacent figure.
N.B.:
with this working program pressure on the drive pedal
brings the brush heads and the squeegee to the work position (in
contact with the floor). When the drive pedal is pressed, all the
motors are powered. The brush head solenoid valve and the
water system pump are powered up (only if the detergent solution
is other than zero).
N.B.:
In the DS selector, the scrubbing with drying program
symbol (D) is green (see “
”).
N.B.:
the grey symbols show working programs that are not active. the
green symbols show working programs that are active.
N.B.:
when the drive pedal is released all the brush head motors and the suction motor stop with the respective delays. After the “Reset
Delay”time all the brush heads and the squeegee body are taken to the rest position (raised off the floor). by pressing the forward
movement pedal it will start working with the same program and with the same parameters that were set before it stopped.
N.B.:
if you reverse with this program active the brush head will remain in contact with the floor, the motor will continue working but the
solenoid valve will not deliver the detergent solution to the brushes. The squeegee support is put in the rest position (raised off the floor)
and the suction motor is switched off with the relative delay.
The icons that may be visible on the control panel display are:
1. FFM symbol, if visible it shows that the system is operating.
2. FSS symbol, if visible it shows that the system is operating.
3. Side brush head symbol, if visible it shows that the side brush head is in the working position.
4. Working lights symbol, if visible it shows that the working lights are on.
N.B.:
If you need to activate the dipped headlights when working, see the section “
”.
5. General alarm symbol.
ATTENTION:
if visible, stop the machine. To continue working, see “
”.
6.
”).
7.
If the solution tank float symbol is visible, this signals that the solution tank is empty and needs to be refilled (see “
”).
8. Eco-Mode button.
N.B.:
if the Eco-Mode button is pressed in transfer mode, the "scrubbing with drying" program is activated in economic mode.
9. Menu button.
10. Rear camera button.
N.B.:
when the rear view camera button is pressed (if present), the camera located at the back of the machine will be activated, see
” to continue working.
11. Zone button
N.B.:
if you need to change the program in use when working, press the Zone button (read the section “
12. Text indicator.
N.B.:
the text indicator shows which zone program has been selected, or whether the machine is in transport mode if the word “DRIVE” is
visible.
OFFICE
0000.00
100%
9
12
8
10
11
1
5
6
7
2
3
4
ATTENTION: never switch off the machine while the squeegee and/or brush head is in contact with the floor
26
