SCRUBBING WITHOUT DRYING
By selecting the "SCRUBBING WITHOUT DRYING” program, the
command display screen will appear as in the adjacent figure.
N.B.:
with this working program pressure on the drive pedal only
brings the brush heads to the work position (in contact with the
floor), while the squeegee remains in the rest position (raised
from the floor). The brush head solenoid valve and the water
system pump are powered up (only if the detergent solution is
other than zero). When the drive pedal is pressed the brush
heads, the solenoid valve, the electric pump and the traction
motor are powered up.
N.B.:
In the DS selector, the scrubbing without drying program
symbol (B) is green (read the paragraph “
”.
N.B.:
the grey symbols show working programs that are not active. the green symbols show working programs that are active.
N.B.:
when the drive pedal is released all the brush head motors stop with the respective delays. After the “Reset Delay”time all the brush
heads are taken to the rest position (raised off the floor). by pressing the forward movement pedal it will start working with the same
program and with the same parameters that were set before it stopped.
N.B.:
if you reverse with this program active the brush head will remain in contact with the floor, the motor will continue working but the
solenoid valve will not deliver the detergent solution to the brushes.
The icons that may be visible on the control panel display are:
1. FFM symbol, if visible it shows that the system is operating.
2. FSS symbol, if visible it shows that the system is operating.
3. Side brush head symbol, if visible it shows that the side brush head is in the working position.
4. Working lights symbol, if visible it shows that the working lights are on.
N.B.:
If you need to activate the dipped headlights when working, see the section “
”.
5. General alarm symbol.
ATTENTION:
if visible, stop the machine. To continue working, see “
”.
6.
”).
7.
If the solution tank float symbol is visible, this signals that the solution tank is empty and needs to be refilled (see “
”).
8. Eco-Mode button.
N.B.:
if the Eco-Mode button is pressed in transfer mode, the "scrubbing with drying" program is activated in economic mode.
9. Menu button.
10. Rear camera button.
N.B.:
when the rear view camera button is pressed (if present), the camera located at the back of the machine will be activated, see
” to continue working.
11. Zone button
N.B.:
if you need to change the program in use when working, press the Zone button (read the section “
12. Text indicator.
N.B.:
the text indicator shows which zone program has been selected, or whether the machine is in transport mode if the word “DRIVE” is
visible.
ATTENTION: never switch off the machine while the squeegee and/or brush head is in contact with the floor
OFFICE
0000.00
100%
9
12
8
10
11
1
5
6
7
2
3
4
24
