DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
1.
EMPTYING THE COLLECTION TANK
To empty the collection tank of solid waste, proceed as follows:
1.
Take the appliance to the designated place for emptying the collection tank.
2.
Do what is required to make sure the machine is in a safe condition (see
MACHINE SAFETY’
”).
WARNING: The place this operation is carried out should comply with current
environmental protection regulations.
3.
Remove the vacuum hose (1) turning it anti-clockwise and remove it from the vacuum nozzle (2) in the
collection tank.
WARNING: you are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands.
4.
Free the vacuum head from the collection tank, using the lever (3) on the front rear part of the collection
tank, moving the lever as indicated by the arrow in the picture on the side.
5.
Using the handle (4), in the vacuum head assembly, remove the vacuum head assembly from the
collection tank (rotating it and shifting it as indicated in the figure).
6.
Lay the head gently on the floor.
7.
Remove the dirt from the collection tank.
8.
Repeat the operations in reverse to reassemble.
If, on the other hand, there is the filter – paper collection bag, just take it out from the tank, being careful not
to damage the cardboard support in the bag or tear the bag itself. Throw the bag in the designated waste
area.
WARNING: The place this operation is carried out should comply with current
environmental protection regulations.
WARNING: Remove the filter – collection bag only when it is completely full.
Page 15
