AT THE END OF THE WORK
At the end of work, and before carrying out any type of maintenance, perform the following operations:
1.
Do what is required to make sure the machine is in a safe condition (see
MACHINE SAFETY’
”).
2.
Take the appliance to the designated place for emptying the collection tank.
3.
Empty the collection tank (see the section “
EMPTYING THE COLLECTION TANK
”).
WARNING: The place this operation is carried out should comply with current
environmental protection regulations.
4.
Remove the accessory from the extension, clean it under a jet of running water and place it in the
accessory holder (1).
5.
Disconnect the extension end and clean it under a jet of running water.
6.
Remove the extension inside the nozzle in the vacuum hose, clean it under a jet of running water.
7.
Take the appliance to the designated machine storage place.
8.
Wind the power cable around the cable winder (2) on the bottom of the handle (only valid for FV15
versions).
9.
Insert the vacuum hose fixing clip (3) into the support at the rear of the collection tank.
WARNING: Park the appliance in an enclosed place, on a flat surface; near the
appliance there must be no objects that could either damage it, or be damaged
through contact with it.
If you want, you can lay the rear of the collection tank on the ground and insert the vacuum hose fixing clip
(4) into the tube support on the bottom of the collection tank.
If you want, (for FV15 versions) you can lay the vacuum hose fixing clip (5) in the front of the handle.
2
3
4
Page 14
