5. Eco-Mode button.
N.B.:
if the Eco-Mode button (8) is pressed in the transfer mode the scrubbing with drying program is started in economic mode.
6. Menu button.
7. Rear view camera button.
N.B.:
when the rear view camera button (7) is pressed (if present), the camera located at the back of the machine will be activated, see
REAR VIDEO CAMERA (PLUS VERSION, OPTIONAL)
” to continue working.
8. Zone button.
N.B.:
if the Zone button (8) is pressed in transfer mode, the window for selecting the zone opens (read the section “ZONE PROGRAM
MODE”); after selecting a zone, the machine shifts into scrubbing with drying mode with the program of the zone selected.
9. Text indicator.
N.B.:
in the text indicator (9) it is possible to see that the zone program has been selected or whether you are in transport mode if there is
the word “DRIVE”.
N.B.:
If it is necessary to turn on the low beam headlights during transfer, see “
WORKING HEADLIGHTS (PLUS VERSION)
”.
SCRUBBING WITHOUT DRYING
By selecting the "SCRUBBING WITHOUT DRYING” program, the
command display screen will appear as in the adjacent figure.
N.B.:
with this working program pressure on the drive pedal only
brings the brush heads to the work position (in contact with the
floor), while the squeegee remains in the rest position (raised
from the floor). The brush head solenoid valve and the water
system pump are powered up (only if the detergent solution is
other than zero). When the drive pedal is pressed the brush
heads, the solenoid valve, the electric pump and the traction
motor are powered up.
N.B.:
In the DS selector, the scrubbing without drying program
symbol (B) is green (read the paragraph “
”.
N.B.:
the grey symbols show working programs that are not active. the green symbols show working programs that are active.
N.B.:
when the drive pedal is released all the brush head motors stop with the respective delays. After the “Reset Delay”time all the brush
heads are taken to the rest position (raised off the floor). by pressing the forward movement pedal it will start working with the same
program and with the same parameters that were set before it stopped.
N.B.:
if you reverse with this program active the brush head will remain in contact with the floor, the motor will continue working but the
solenoid valve will not deliver the detergent solution to the brushes.
The icons that may be visible on the control panel display are:
1. FFM symbol, if visible it shows that the system is operating.
2. FSS symbol, if visible it shows that the system is operating.
3. Working lights symbol, if visible it shows that the working lights are on.
4. General alarm symbol.
ATTENTION:
if this is visible, stop the machine; to continue working, see “
”.
5. Eco-Mode button.
N.B.:
if the Eco Mode button (8) is pressed, the working program currently in use will be activated in Eco Mode; to deactivate Eco Mode,
see “
”.
6. Menu button.
7. Rear view camera button.
N.B.:
when the rear view camera button (7) is pressed (if present), the camera located at the back of the machine will be activated, see
REAR VIDEO CAMERA (PLUS VERSION, OPTIONAL)
” to continue working.
OFFICE
0000.00
100%
6
5
7
8
9
1
4
2
3
24
