N.B.:
the right-hand and left-hand knobs must be rotated the same number of times, so that the squeegee is parallel to the floor when it is
working.
N.B.:
Check for proper adjustment by looking at the instrument (8) positioned on the squeegee body (
Fig.5
).
Adjusting the tilt of the squeegee body:
•
To adjust the inclination of the squeegee body rubber blades with respect to the floor, tighten or loosen the knob (9) (
Fig.6
), until the
squeegee body rubber blades are bent towards the outside evenly along the entire length by about 30° with respect to the floor.
N.B.:
Figure 6 indicates the direction of rotation for tilting the squeegee towards the rear of the machine (
Fig.7
). Turn it in the opposite
direction to rotate the squeegee towards the front of the machine.
N.B.:
Check for proper adjustment by looking at the instrument (10) positioned on the squeegee body (
Fig.8
).
5
4
7
8
7
8
6
9
10
ADJUSTING BRUSH HEAD BODY SIDE SPLASH GUARDS
If the side splash guards of the brush head body are not positioned correctly they cannot do their work properly, namely convey the dirty
detergent solution towards the squeegee, therefore the height of the splash guard needs to be adjusted.
This operation can be done with the brush head body in the work position, proceeding as follows:
1. Lower the brush head body, and for PRO versions, press the “BRUSH HEAD CONTROL” button (1) on the control panel (
Fig.1
). For PLUS
versions, using the DS selector on the control display (
Fig.2
), select the “scrubbing with drying” program (3) (see “
N.B.:
as soon as the button (1) on the control panel is pressed, the green LED (2) (“BRUSH HEAD BODY WORK POSITION”) will switch
on (
Fig.1
).
2. For PRO versions, lower the squeegee body and press the “SQUEEGEE CONTROL” button (4) on the control panel (
Fig.1
).
N.B.:
as soon as the button (4) on the control panel is pressed, the green LED (5) (“SQUEEGEE BODY WORK POSITION”) will switch on
(
Fig.1
).
3. Press the drive pedal (6) (
Fig.3
) to begin moving the machine.
4. As soon as the brush head and the squeegee have reached their working positions, perform the procedure for securing the machine (see
”).
5. Go to the front left-hand side of the machine.
6. Remove the left splash guard (7), unscrew the knobs (8) on the brush head body (
Fig.4
).
7.
Adjust the height of the splash guard with respect to the floor, tighten or loosen the knobs (9) until the splash guard touches the floor along
its entire length (
Fig.5
).
N.B.:
By turning the knobs (9) clockwise, the splash guard support moves towards the floor (
Fig.5
).
N.B.:
Both the front and rear of the splashguard need to be at the same height off the floor.
8. Once the adjustment has been made, reposition the left splash guard (7) and tighten the knobs (8).
9. Repeat the operations just carried out also for the right side centre as well.
3
6
Back
0000.00
100%
1
2
5
2
4
1
3
4
5
8
7
9
44
