PROGRAM ZONE MODE (PRO VERSION)
The "PROGRAM ZONE" modes foresees the use of three functions already stored in the machine's internal
memory, levels:
• Forward speed
•
Adjustment of the detergent solution flow
•
Suction motor efficiency
are pre-set and have been created on the basis of the type of environment where you want to work.
To select an area program, just press the relative button (1) on the control panel (
Fig.1
).
N.B.:
when an area program is active, the relative LED (2) will light up on the control panel (
Fig.1
).
N.B.:
if you want to change the levels of the above parameters of the "AREA" functions, just make the necessary modifications then press
and hold the button of the relative program for about three seconds. The modification will be recorded when the LED starts flashing.
1
1
2
PROGRAM ZONE MODE (PLUS VERSION)
The zone programs are programs saved in the machine's memory, the parameter levels:
• Pressure exercised on the central brush head
• Forward speed
•
Adjustment of the detergent solution flow
•
Suction motor efficiency
These are set and have been created on the basis of the type of environment where you want to work.
To select one of the zone programs, proceed as follows:
1. From any screen, press the “ZONE” button (1) (
Fig.1
).
2. As soon as the button (1) is pressed, the “ZONE SELECTION” menu will be displayed (
Fig.2
). Select
one of the programs.
N.B.:
the name of the zone program selected is displayed in the text indicator (3) (
Fig.1
).
N.B.:
to exit the zone program:
• From the zone program menu select the “EXIT” key
• Enable and then disable the ECO-MODE key.
N.B.:
the light blue ZONE key shows that the selected zone is active, in this case the ECO-MODE button is not active.
N.B.:
to activate or deactivate “PROGRAM ZONE” mode, see the programming manual.
MANUAL
0000.00
100%
Warehouse
Canteen
Office
Reception
Exit
SELEZIONE ZONE
0000.00
100%
1
2
1
3
2
INTELLIGENT DRYING MODE (PLUS VERSIONS)
When moving from the scrubbing with drying program to the transfer program (see “
”), the drying function is delayed by a “Reset Delay” time.
N.B.:
While the function is active, the image in
Fig.1
will be displayed on the control panel.
At the end of the "Reset Delay" time, the squeegee body is moved into the rest position (raised off the floor) and
the suction motor is switched off with its "Reset Delay" time.
N.B.:
it is possible to cancel this function in advance by pressing the “X” symbol as seen in
Fig.1
.
N.B.:
at the end of the smart drying function, the image in
Fig.2
will be displayed on the control panel.
1
2
29
